|
 |
|
|
|
|
| |
|
Directions from the Pittsburgh
International Airport
|
|
- Exit the airport terminal onto Route 60 South, heading
towards Pittsburgh. (Route 60 South becomes Route 22/30
and then becomes Interstate 279 North as you approach downtown
Pittsburgh.)
- Continue on Interstate 279 towards Pittsburgh for approximately
15 miles.
- Watch for the signs to enter the Fort Pitt tunnel. As
you enter the tunnel, be sure that you are in the left-hand
lane. (After exiting the tunnel, you will be on the Fort
Pitt Bridge.)
- Once out of the tunnels and on the Fort Pitt Bridge, merge
into the left-most lane and follow signs to Route 28 (This
lane puts you onto the Fort Duquesne Bridge.)
- Once on the Fort Duquesne Bridge, move into the right-most
lane, and take the first exit onto Route 28 North.
- Remain on Route 28 North for about 7 miles until you reach
Exit 10 -- RIDC Park. (The Emerson Process Management Power
& Water Solutions (formerly Westinghouse Process Control)
building will be visible on your right from Route 28.)
- At the bottom of the Exit 10 ramp, turn right onto Beta
Drive.
- Continue on Beta Drive to Emerson Process Management Power
& Water Solutions and turn left into the second driveway
- To get to our main lobby, make an immediate left into
the visitor parking lot. Or, if you are visiting the Training
Center, make an immediate right into the visitor parking
lot in front of the Training Center.
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
